Endon EL-KALAMOS Instruction Manual

Safety Warnings

These products are only suitable for connection to a 240V~50Hz supply in accordance with current
IEE wiring Regulations and should be installed in accordance with local Building Regulations and
are for Domestic wall use only.
These mirror lights have an IP44 rating and may be installed in "Zones 1 and 2 and Outside Zones"
of a bathroom and the supply circuit protected by an RCD.
These zones are referenced in BS 7671: 2008 "Requirements for Electrical Installations", IEE Wiring
Regulations 17 th Edition – see associated diagram.
These mirror lights should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker) and an RCD when the fittings are used in a bathroom.
If in doubt we recommend you contact a qualified electrician.
Be careful during handling and maintenance to avoid breakage of the glass parts.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
If the glass cover (mirror) is broken or cracked then it must be replaced immediately to preserve the
water ingress protection, please consult your retailer. This is represented by the symbol
These fittings are heavy and you will require assistance in connecting them to the supply and
securing them to the mounting surface.
These mirrors have (non-replaceable) LED`s fitted. We recommend that you do not stare directly into
the LED light beams.
If any modification is made it will invalidate the warranty and may render the product unsafe.
Please read these instructions carefully before fitting your new mirror and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Make sure that there is a 200mm space between the sensor and any other surface eg sink, shelf etc.
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws / nuts, including electrical connections etc are fully tightened before use.
This mirror should not be connected to a Dimmer.
The Light pack contains:
IP rated wall mirror with proximity switch and
demister.
EL-KALAMOS AND EL-KASTOS MIRRORS
INSTRUCTION MANUAL
NOTE:-

Before you start

The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
1
Wire strippers.
Electrical insulation tape.
1. A shower tray is shown here,
a bath has equivalent
dimensions.
2. Basins should be regarded as
having a 600mm Zone 2
hemi-sphere above and
extending down to the floor.
(If in doubt refer to the latest
edition of BS 7671, or a
qualified electrician).