CAN CU2000 Instructions Manual page 14

The appliance, but above all, the rear parts must never be in contact with wood, plastic and
IT
inflammable objects or surfaces.
It is strictly forbidden to use the appliance as a heat source (heater).
UK
Adequate ventilation must be planned as this appliance is not connected to a smoke collec-
tion system produced by gas combustion in the burners towards the outside of the premises.
FR
The special ventilation openings must be open before beginning to use the appliance and
kept always open when the appliance is operating in compliance with the current regulations
in force.
DE
The amount of air required is 2,000 litres per hour for each kilowatt of rated power of the
appliance.
Warning: The appliance must not be installed in an area subject to strong drafts.
Do not use aerosol sprays near the appliance.
Heat and damp is released in the room when using a gas appliance, it is therefore mandatory
to make sure that the room is well ventilated, and hence keep opened the special ventilation
openings, or install a ventilation system (hood or other); a prolonged use of the appliance could
make an additional ventilation necessary (for example, open a window).
Assembly of the ovens in the cabinet:
the installation compartment that houses the oven, must have the dimensions shown in Fig. 1.
Depth P of the compartment varies with the degree of tilting that it is wished to be planned;
fix the hooking brackets with ø 4 screws by placing them according to the dimensions indi-
cated in Fig. 1;
14
Balance bracket
Fig. 1