One Identity Safeguard for Privileged Sessions T1 Installation Manual page 19

documents:
For Safeguard Sessions Appliance 3000 and 3500, see the X9 SMT IPMI User's Guide.
4. Power on the server.
5. Login to the IPMI web interface, and boot the One Identity Safeguard for Privileged
Sessions installation CD on the server using a virtual CD-ROM. For details, see the
following documents:
For Safeguard Sessions Appliance 3000 and 3500, see the X9 SMT IPMI User's Guide.
6. When the One Identity Safeguard for Privileged Sessions installer starts, select
Installer, press Enter, and wait until the server finishes the boot process.
TIP:
For testing purposes, you can speed up installation at the expense of slowing down
RAID synchronization. Add the following kernel parameter to Installer in GRUB:
lazy_itable_init=true
This option defers full filesystem initialization, requiring the kernel to finish it
during RAID synchronization, which slows that process down considerably. This is
not recommended in a production environment.
7. Installing SPS will completely delete the contents of the hard disks. If you want
to proceed installing SPS, enterYESto start the installation process. Depending on
the size of the disks, the installation process takes from a few minutes to an
hour to complete.
CAUTION:
Hazard of data loss All data on the disks will be deleted.
8. The installer displays the following message: Waiting for RAID
to synchronize the disks of SPS.
You are recommended to wait until the synchronization finishes. RAID
l
synchronization is a two-step process, the progress of the active step is
indicated on the progress bar. Wait until both steps are completed. Note that
this synchronization takes several hours, depending on the size of the hard
disks (about 8 hours on the average).
To skip the RAID synchronization, pressCtrl+Alt+Deleteto reboot SPS. Note
l
that the system will automatically perform the synchronization after the first
boot, but in this case the process will take several days.
9. When the installation is finished, the Installation finished successfully message is
displayed. Unmount the installation media, then press Ctrl+Alt+Delete to reboot SPS.
Wait until the system reboots and displays the IP address it accepts management
connections on.
10. If you are installing the slave node of a SPS cluster, skip this step. Enter the IP
address displayed in the previous step into your browser and verify that the Welcome
Wizard of the One Identity Safeguard for Privileged Sessions is available. (If you
One Identity Safeguard for Privileged Sessions Software Installation Guide
sync..., and starts
SPS 6.6.1 Installation Guide
19