Safety Precautions - SPX OTC Motor-Rotor 1735A Parts List & Operating Instructions

Parts List & Operating Instructions
CAutION: to prevent personal injury and/ or property damage,
•
Study, understand, and follow all safety precautions and operating instructions before
using this repair stand. If the operator cannot read instructions, operating instructions
and safety precautions must be read and discussed in the operator's native language.
•
Only qualified operators may install, operate, adjust, maintain, clean, repair, inspect, or
transport this repair stand.
•
Wear eye protection that meets ANSI Z87.1, CE EN166, AS/NZS 1337, and OSHA
standards.
•
do not exceed the rated capacity of 907 kg (2000 lbs.).
•
use only on a hard, level surface.
•
Ensure the load is centered and secured to mounting attachments. use metric property
class 8.8 or SAE grade 5 cap screws (or better) to attach mounting adapters to the repair
stand and to the component. Mount the engine so weight is balanced within 51 mm (2.0
inches) of the repair stand centerline.
•
An engine that weighs less than 454 kg (1,000 lbs.) may be mounted with a minimum of
four (4) adjust-a-grip arms; an engine that weighs more than 454 kg (1,000 lbs.) must be
Slowly
mounted with special adapters or with a minimum of six (6) adjust-a-grip arms.
•
rotate large components slowly to avoid bouncing.
•
Move the repair stand SLOWLy to avoid tipping.
•
Slowly Never work under an engine or any other component mounted to this repair stand.
•
do not use this repair stand for anything other than its intended purpose.
•
No alteration shall be made to this product. use only those attachments and / or adapters
supplied by the manufacturer.
•
Inspect the condition of the repair stand before each use; do not use if damaged, altered,
or in poor condition.
•
use only those repair parts called out in the parts list in this document. Items found in
the parts list have been carefully tested and selected by SPX Service Solutions.
Form No. 538577, Sheet 1 of 5, Back

Safety Precautions