3.5 The Way To Change The Wear And Tear Parts - Pyle PRMC720 Manual

3.4 The Way To Adjust The Up / Down Screw
Due to long transportation and long use,
the screw will be loose.When the counting
is not accurate, it is necessary to turn the
up/down screw clockwise to increase the
friction

3.5 The Way To Change The Wear And Tear Parts

When the rubber tongue is worn out,
please flip it and use the other side.
10
Operation Instruction
tighten loosen
Adjust the up/down screw
3.6 Troubleshooting Operational Problems
Note: when counting and detecting is not accurate, please check the machine
as following
The power line cord is The fuse is worn out?
connected well?
No power
The hopper sensor is dirty,
Connect the Hopper sensor
please clean by brush line well to the main board
The power
is on , but
no working
Turn the screw clock wise Maybe Counting sensor
to increase the friction
is dirty , please clean it
Wrong
tighten loosen
counting
Maybe the MG is dirty,
Adjust the MG sensor
please clean it
Wrong
detecting
9 11
Operation Instruction
The power switch is on ?
The belt is too loose or too
tight, please make the belt
rightly.
Maybe the rubber tongue
is worn out, please change
to the other side or a new
one
Counting
sensor
Maybe UV sensor is broken
or dirty, please clean it or
change a new one