Pyle PRMC720 Manual page 6

■Photo 3.2.7
3.2.7 Mode Of Adding Count
UV MG IR MT
DD
Press ADD button,the machine is into
add counting mode, it adds up the last
COUNT
PCS counting number with the next counting
BAT
ADD
number.（photo 3.2.7）
AUTO
PCS
3.2.8 The Mode Of Checking
The Fake And Suspicious
The machine will stop and beep
when counting the broken or half bills.
the machine will stop and beep while
counting the fake bills/Suspicious bills.
（Photo 3.2.8）
■Photo 3.2.3
3.2.9 Mode Of Batch Counting
UV MG IR MT
DD
on, then the machine is into batch counting
COUNT
mode,Preset batch number by Press 0/1/2
PCS
BAT
/3/4/5/6/7/8/9, the machine will stop coun-
ADD
AUTO
ting when the counting number is up to the
PCS
batch number
（Photo 3.2.9）
8
Operation Instruction
■Photo 3.2.2
EE1
>FAKE NOTE
COUNT
>SUSPICIOUS NOTE
BAT
ADD
Remove note and press
AUTO
[reset] to continue
Press BAT/C button, BAT indicator lights
3.3 Error -Message Dispaly
Code No. Malfunction causes
The left counting sensor is broken or dirty
E01
E02 The right counting sensor is broken or dirty
E03 The code disc is dirty or loosen
E04
The hopper sensor is broken or dirty
E05
The stacker sensor is broken or dirty
Ambient light is too high
E10
UV sensitivity light is too high
The plastic button is broken or loose
E11
Alarms meaning
Code No.
The fake bill reflecting fluorescence is being
EE1
checked out by UV
The fake bill without magnet is being checked
EE2
out by MG
The fake bill or suspicious bill is being
EE3
checked out by IR
The half bill is being checked out
EE4
The left(right) counting sensor is dirty or brocken
Two bills are counted as one/inaccurate counting
EE5
The fake bill or suspicious bill with different
EE6 located magnetic is being checked out by MG
The bill wide length size is not within the range of
EE8
110-180mm
9
Operation Instruction
Solutions
To change a new one or clean it
To change a new one or clean it
To clean it or tight it
To change a new one or clean it
To change a new one or clean it
To lower the ambient light
To lower the UV light
To change a new one or tight the connector
Solutions
At first , to take out the first bill (fake bill) in
the stacker then to press [reset] to continue
counting and detecting
At first , to take out the first bill (fake bill)
in the stacker then to press [reset] to
continue counting and detecting
Take out the first bill(fake bill or suspicious bill)
in the stacker,then press(reset)to continue
counting and detecting
Take the half bill in stacker,then press(reset)
to continue counting and detecting
To clean it or change a new one
To tight the adjustable screw clockwise
Take out the first bill(fake bill or suspicious
bill)in the stacker,then press(reset)to
continue counting and detecting
Take out the first bill(fake bill or suspicious
bill)in the stacker,then press(reset)to
continue counting and detecting