Operating/Safety Procedures - Gearmore 12 UNIV Operation, Service & Parts Manual

OPERATING/SAFETY PROCEDURES

Keep in mind that the lift capacity of the machine can be greatly reduced by a number of
factors, including:
1.
Operating on a grade, especially across a grade.
2.
Operating on uneven, soft, bumpy or rough terrain.
3.
Under-inflated tires.
Double-tiered loads are hard to control and should not be lifted.
If there is any question about being able to lift the load, stop and separate the load
into smaller lifts.
Remember that the weight of the forklift attachment is the same as carrying a partial
load. In this case, operate the machine as if you were transporting a partial load.
Carry the load low - always at the lowest possible bucket height recognizing the
irregularities in the surface of the working area.
Keep your speed low enough so that you are in complete control at all times.
Operate your machine only from the operator's seat.
Sudden stops, starts, turns, or changes in direction can cause the load to fall or the
machine to overturn.
Keep others away from your operation. NEVER allow anyone to stand or pass
under a raised load.
NEVER drive a fork equipped machine up to someone standing in front of a
fixed object.
If overload causes the machine to tip - lower the load immediately.
If loads are to be re-handled, place stacking blocks under the load.
Page 4