Know The Work Area - Gearmore 12 UNIV Operation, Service & Parts Manual

KNOW THE WORK AREA

Before you operate, learn as much as possible about the work area.
Walk around the worksite and inspect the surface(s) over which you will be expected to travel.
AVOID:
⇒
⇒
⇒
⇒
⇒
⇒
⇒
⇒
⇒
⇒
If any of the above listed conditions exist in the work area, correct the condition before operating.
If the condition cannot be corrected, avoid operating in the problem area.
Holes
Drop-offs
Obstacles
Rough Spots
Soft Soil
Deep Mud
Standing Water
Oil Spills
Wet Spots
Slippery Surfaces
When operating on docks, ramps or floors, check for weak
spots. Clear away trash and debris. Pick up anything that
could puncture a tire.
Watch for any condition that could cause:
Check overhead clearances. Know the size of doorways and
canopies. Know exactly how much clearance you have under
power lines and telephone lines.
IMPORTANT: DO NOT approach power lines, overhead
or underground cables or other power sources with any part of your
forklift unless all local, state/provincial and federal regulations have
been met and the appropriate utility company or digger's hotline has
been contacted to de-energize the lines.
♦
Loss of Control
♦
A Collision
♦
Tipover
Page 3