Troubleshooting - Plastica SOLAR POD PLUS Owner's Manual

Table of Contents

Advertisement

Problem
1) The item does not appear to be heating the pool.
2) There is no initial bubbling after heater is
connected and pump is on.
3) Bubbles continue to flow out of the pool water inlet
well after the pump has been turned on.
4) Leaking heater
Solar Pod Plus_v2_11/2019

7. TROUBLESHOOTING

Possibilities/Solutions:
8
• Check to make sure that water is flowing through
the tubes. Check the flow strength at the pool inlet.
• Has it been sunny?
• Put your pool cover on at night to prevent heat loss.
• Additional heaters may be necessary.
• Ensure that the Solar Pod Plus is operating solely
between 10am and 6pm
• Check the setting of the filter to make sure it is
returning water to the pool through the pool water
inlet.
• Check flow rate.
• Check the connections for a suction leak.
• Check to make sure the flow rate is normal.
• There could be a break in the tubing.
• There could be a blockage in the tubing, try to
purge the tube.
• Check the connector seals and replace or repair if
defective.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SOLAR POD PLUS and is the answer not in the manual?

Table of Contents