Advertisement
5. maIntenance / StoraGe
5.1.
Always disconnect the heater from the gas cylinder before putting the heater into storage. if for any reason the heater is to be stored
indoors, the tank MUST be disconnected from the Gas cylinder, and the cylinder stored outdoors in a well-ventilated area, out of the reach
of children. The plastic valve plug or valve cover supplied with the cylinder must be re-installed on the valve to protect the fitting from
damage.
5.2.
if the supply cord is damaged, it must be replaced by a special cord or assemble available from the manufacturer or its service agent. if
the supply cord is damaged, it must be replaced by a special cord or assemble available from the manufacturer or its service agent.
▲
DanGer! never store a gas cylinder inside of a building or near any other gas or oil burning appliances.
note:- Installation and repair of this heater should be done by a qualified service person.
ALWAYS be sure to follow proper maintenance procedures. This should include cleaning the inside of the heater once a month and
checking the spark gap at least once a heating season. Re-gap the terminals to 4mm.
6. trouBLeShootInG
Problem
fan does not turn when electricity is
connected
Heater will not ignite
Heater stops running by itself
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Possible cause
no electric power to heater
Blades of fan in contact with heater housing check housing for damage. Be sure there
fan blades bent
fan motor defective
no spark at module
incorrect spark gap
corroded electrodes
temperature inside heater is too high,
causing thermal switch to shut down
operation.
damaged control valve.
dust or debris accumulated in heater.
solution
check current at outlet. if voltage is correct,
inspect extension and power cords for cuts,
frays or breaks.
are no dents in the housing obstructing the
fan.
straighten all fan blades
replace motor assembly
inspect module wire. Re-attach or tighten
if loose. inspect spark module and replace
if necessary. inspect all other electrical
components.
set spark ignition gap to 4mm.
replace spark ignition plug
if the heater input or output is restricted,
the inside temperature can become too hot.
Keep the areas in front and behind clear of
obstructions.
replace control valve
clean inside of heater
Advertisement
