Advertisement
Keep children away from the heater.
9
Keep the heater clean and in good working order.
9
ensure that the heater is correctly turned off and the gas source isolated when not in use.
9
When not in use for any length of time, store heater in a safe, dry, childproof location.
9
note: this appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. children shall not play with the appliance. cleaning and user maintenance shall not
be made by children without supervision
2. IntroDuctIon
many uses have found the advantages of propane heaters far outweigh the small additional running costs. the fuel is more completely
burned and does not leave an oily residue as experienced with paraffin heaters. There is no odour, except for the few seconds during start-up
and the units run a little more quietly since they do not need a compressor to drive the fuel to the burner. Available with a durable paint finish
or with a stainless steel body for improved corrosion resistance and stylish appearance.
Heaters are fan assisted, fitted with a piezoelectric ignition system for trouble free starting and feature a direct gas head assembly. Safety
solenoids prevent the heater from leaking gas without first being electrically started. Front foot offers height adjustment allowing the heat
to disperse at different angles. Supplied with an approved propane gas regulator and hose. All models are tested and certified to CE/EN
standards by DVGW. Manufactured to BS EN 416.
3. SpecIfIcatIon
model no ................................................................ lP100.V4
output ............................................................. 19.8 - 28.4KW
output ..................................................68,000 - 97,000Btu/hr
Airflow ........................................................................ 400cfm
fuel consumption .................................................. 1.5-2kg/hr
supply ............................................................................230V
length ........................................................................ 650mm
Width .......................................................................... 230mm
Height ........................................................................ 380mm
fuel ...........................................................................Propane
Heated Area ..............................................................20000ft
Heated Area .............................................................. 566mtr
Weight ........................................................................... 7.8kg
4. operatIon
4.1.
pre Lighting
this heater is not supplied with a gas cylinder. use only an approved gas cylinder.
4.1.1.
Fasten full gas tank and connect fitting to gas cylinder valve by turning
counter-clockwise. fig.2.
4.1.2.
With heater gas valve knob still in OFF position turn ON the gas cylinder valve and
check for leaks with soap solution.
4.1.3.
Inspect the heater before each use, and at least annually by a qualified service person.
4.2.
Igniting the heater
4.2.1.
connect the heater to a three prong (grounded) power source. You must use a three
prong (grounded) extension cable that is at least 6 feet long is of the correct rating.
4.2.2.
Check gas control valve is in "OFF" position. fig.4.
4.2.3.
connect heater to a propane gas cylinder as in 4.1.
4.2.4.
turn gas valve counter clockwise to switch on gas.
4.2.5.
check for gas leaks, if found rectify.
4.2.6.
Push in and turn gas control knob counter clockwise to position 1. this will light the
burner. if needed, keep pressing control knob until the burner lights.
4.2.7.
Keep the valve knob depressed for at least 30 seconds after lighting the burner.
After 30 seconds, release the valve knob.
4.2.8.
if the burner does not stay lit, repeat the lighting procedure.
4.2.9.
When burner stays lit, turn gas valve knob to desired setting fig.4.
4.3.
Switching off the heater
4.3.1.
Turn gas valve knob clockwise to "O" (off) position fig.4.
4.3.2.
turn gas supply off by turning the gas cylinder valve clockwise to close.
4.3.3.
disconnect the power cable.
© Jack sealey limited
fig.1
3
3
Original Language Version
fig.2
lP100.V4 | Issue 1 08/09/16
fig.3
fig.3
fig.4
Advertisement
