Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
Preparations
3. Preparations
Material losses
!
Note the maximum load bearing capacity of the
mounting bracket (see chapter "Specification / Data
table").
f Ensure that the wall structure is able to bear the weight of
f
the external unit plus wall mounting bracket.
f Select suitable screws and rawl plugs to secure the system
f
rails on the wall.
Material losses
!
For the following installation steps observe the re-
quired clearance dimensions.
For information, see the operating and installation in-
structions of the external unit (chapter "Dimensions
and connections").
Note
To prevent disturbance due to structure-borne noise
transmission, never install the wall mounting bracket
on the external walls of living areas or bedrooms.
f Install the wall mounting bracket, for example, on
f
a garage wall.
f Mark out the positions of the holes to be drilled on the
f
wall; for this, hold the system rails against the wall at the
required installation height.
Material losses
!
Ensure that no cables/water pipes are damaged
through drilling the holes.
4. Installation
4.1
Securing the angular brackets
f Insert the bolts with washers through the angular bracket
f
from the inside.
f Slide the slide nuts, as illustrated, into the fixing aids.
f
6 |
f Secure the bolts with the slide nuts.
f
f Tighten the bolts lightly. Ensure that the slide nuts are
f
aligned at right angles to the angular brackets.
f Insert the slide nuts into the system rails from above. En-
f
sure that the slide nuts are aligned at right angles to the
system rails.
f Pull the angular brackets along the system rails to the ap-
f
propriate height.
f Tighten all the bolts securely with a spanner.
f
4.2 Securing the assembly to the wall
f Drill the holes.
f
f Insert rawl plugs into the holes.
f
f Insert the bolts with washers and retaining clips through
f
the system rails into the rawl plugs.
f Secure the system rails to the wall.
f
Material losses
!
Ensure that the wall mounting bracket is flush with
the wall.
f Check the alignment of the system rails using a spirit level.
f
f If required, align the system rails by undoing and tighten-
f
ing the bolts.
f Tighten all the bolts securely with a spanner.
f
WK 2
Advertisement
Table of Contents
