Table of Contents
Advertisement
Quick Links
Contents
Introduction ............................................................................................................................... 2
Assembly .................................................................................................................................. 2
Case ................................................................................................................................. 2
Step 1 - Build the Main Board ........................................................................................... 3
Step 2 - Build the Tube Boards ......................................................................................... 4
Step 3 - Build the Colon Towers ........................................ Error! Bookmark not defined.
Step 4 - Final Assembly .................................................................................................... 5
Bill of Materials ......................................................................................................................... 6
Schematic ................................................................................................................................. 8
Warranty Terms and Conditions .............................................................................................. 11
WordClock-3 Assembly Guide 2/25/20 Version 0.6
WordClock-3 Assembly Guide
Page 1
Advertisement
Table of Contents
Related Manuals for Angry Electrons WordClock-3
Summary of Contents for Angry Electrons WordClock-3
-
Page 1: Table Of Contents
Step 3 – Build the Colon Towers ........Error! Bookmark not defined. Step 4 – Final Assembly ....................5 Bill of Materials ......................... 6 Schematic ..........................8 Warranty Terms and Conditions ....................11 WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 1... -
Page 2: Introduction
Introduction WordClock-3 assembly should be attempted only by experienced builders. Although assembly is straightforward and not difficult for experienced kit builders, there are several surface mount parts that must be carefully soldered to the boards. The kit may be returned for a full refund less shipping within 30 days of purchase, only if assembly has not been attempted. -
Page 3: Step 1 - Build The Main Board
Connect a 12v-18v power supply with a center positive, 2.1mm connector to J1, and check the test point for 5v. Do not continue assembly if 5v is not present at the test point. WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 3... -
Page 4: Step 2 - Build The Tube Boards
Step 2 – Build the Tube Boards Cut the leads of all six IV-17 tubes progressively smaller, to make insertion of the leads into the tube boards easier. WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 4... -
Page 5: Step 4 - Final Assembly
Install the SD Card. Install four, 10mm standoffs into the holes on the bottom of the main board, using four screws. This completes WordClock-3 assembly. Refer to the User Manual for setup and operation instructions. WordClock-3 Assembly Guide 2/25/20 Version 0.6... -
Page 6: Bill Of Materials
1 IRFU5305 1 Sensor TEPT4400 light sensor R1, R11, Brown-black-orange-gold or brown-black Resistor 10k ¼ watt black-red-gold 0.47R ¼ R2, R6 Resistor yellow-violet-silver-gold watt brown-red-yellow-gold or brown-red-black- 1 Resistor 180R ¼ watt orange-gold WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 6... - Page 7 1 SD Card programmed with WordClock languages database 1 Main Board 8 Tube Board for IV-17 tubes 16 2x6 Male Header 16 2x6 Female Header 1 1x40 Female for ESP32 microcontroller Header WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 7...
-
Page 8: Schematic
Schematic WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 8... - Page 9 WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 9...
- Page 10 WordClock-3 Assembly Guide 2/25/20 Version 0.6 Page 10...
-
Page 11: Warranty Terms And Conditions
This software and hardware product is Copyright (C) 2019 by Mitchell Feig. It is exclusively distributed by OCEAN7 Watch Company d/b/a Angry Electrons (“AE”). All Rights Reserved. AE warrants that for a period of 90 days following delivery, AE kit parts will (a) perform in accordance with published specifications, and (b) will be free from defects in materials and workmanship.
Need help?
Do you have a question about the WordClock-3 and is the answer not in the manual?
Questions and answers