Environmental Protection; Operation Tips; Maintenance - Ryobi RCO2300 Original Instructions Manual

6. Cutting depth lock nut
7. Mitre guide
8. Wrench
9. Upper guard
10. Lower guard
11. Cutting wheel
12. Work clamp
13. Work clamp lock lever
14. Work clamp adjustment crank
15. Rubber foot
16. Saw head lock chain
17. Mounting hole
18. Carbon brush cap
19. Carbon brush
20.
21. Mitre guide lock lever

OPERATION TIPS

MITRE GUIDE LOCK LEVER
When the mitre guide is placed closest to the saw head
pivot, the mitre guide lock lever may interfere with the
head pivot when turning. Repeat the locking process by
lifting and rewinding the lever until the mitre guide is tightly
locked.

MAINTENANCE

Do not modify the product in any way or use accessories
not approved by the manufacturer. Your safety and that
of others may be compromised.
Do not use the product if any switches, guards or
other functions does not work as intended. Return to
an authorised service centre for professional repair or
adjustment.
Do not make any adjustments while the motor is in
motion.
Always make sure the machine's plug has been
removed from the mains power source before changing
brushes, lubricating or when doing any works or
maintenance on the machine.
After each use, check your machine for damage or
broken parts and keep it in top working condition by
repairing or replacing parts immediately.
Ensure that ventilation openings are kept clear,
especially when working in dusty conditions. If it
becomes necessary to clear dust, disconnect the
product from the mains supply. Clean the openings
using a soft brush.
Clean out accumulated dust.
To assure safety and reliability, all repairs with the
performed by an authorised service centre.
If the power cord is damaged, it must be replaced by
an authorised service centre in order to avoid a hazard.
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised service centre.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging
environmental-friendly recycling.
SYMBOLS
Safety alert
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Please read the instructions carefully before
starting the product.
Class II tool, double insulation
Wear ear protection
Wear eye protection.
Not for wet grinding or cutting
Do not use chipped, cracked or defective
grinding wheel
Wear safety gloves
Wear dust mask.
Safety
should be sorted for
5