Advertisement
more than doubled with the UVC radiation.
As for the 6-series (618, 624, 636, 655, 672) SunSun has installed in the housing of the CUV-600 just
like in the CUV-300 series is a sophisticated water supply, the water is displaced by the Was-
serstörmung into a rotary motion. There is no ornate to clean Helix verbaut.Gleichzeitig SunSun has a
stainless steel mirror mounted, which ensures that the UV light is reflected. Light which was not ab-
sorbed directly, is mirrored in the pond water and can act again there. Thus, the contact time and the
intensity of the water to be clarified is more than doubled with the UVC radiation. For effective magnet-
ization of the pond water 2 large ferrite magnets were installed in the housing.
INSTRUCTION
1. This equipment can kill the harmful gems and algae in the aquarium and the pond which offer
the heath environment to the fishes.
2. When the water under the irradiation of wavelength in 253.7nm's ultraviolet radiation in a short
period, the germ and pathogen in the water will be killed then.
3. This equipment is not sell with the pump, please buy it yourself.
4. Please connect the inlet pipe with the outlet of the water pump,
5. Please connect the outlet pipe with the other filter or the pond and fix it. After the inspection of
the pipe a connecting part, the water circulation can be started then.
6. Please check it when the water started circulation or not after several minutes,
7. Turning on electrical source, the UV filter begin to work.
8. The detailed sketch map of usage can be pound in the packing box.
Installation and connection
Installation location
•
This device can only be worked under the protection of the cover. It should be placed in some-
where that water will not submerge it, and it should be installed 2 meters away from water.
Connection
•
We would suggest choosing o hose that can have pressure of O bar.
•
Cut off the multistage hose toil according to the diameter of the hose.
•
Connect the multistage hose tail to the inlet or outlet, and fix with hose clip.
•
Put O—ring into the screw and connect to the device.
You can change the two inlet checking windows to water supply hose if necessary.
Important: Connect the water pumps first, and then connect the UV device. Do not run the device
without water.
This device will be automatically turned on after the power cord is connected to the power supply.The
device is working if the blue light is turned on.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Januar 2020 Version 1
Seite 5
Advertisement
