Advertisement
5. Maintenance
5.1.
The Air Jack/Support Stand is best operated with an in-line oiler. If using
the jack without an oiler, complete the following steps before each use, or
every hour if used continuously:
5.2.
disconnect the jack from the air hose.
5.3.
Apply a few drops of good quality pneumatic tool oil through the air line.
5.4.
inspections should be made before each use of jack, checking for abnormal
conditions. regular inspections should be made weekly for daily use and
monthly for intermittent use.
5.5.
inspect air hose for leaks or kinks. replace if necessary.
5.6.
Air control valve should operate freely. Wheels should rotate freely.
5.7.
the post should extend and retract smoothly throughout its full range.
if jack does not lift smoothly, remove bolts around cylinder cover, remove
cover and lift piston assembly to the piston stops. tilt the assembly to clear
the piston stops. clean and lubricate.
5.8.
A periodic coating of light lubricating oil to all rotating and sliding portions
of the jack will help to prevent rust and assure that the wheels move freely.
5.9.
lower the saddle to its lowest position when not in use.
5.10.
When jack is not in use, tip it forward until it rests on the wheels and use
extra support to hold the jack fig.3. This allows trapped water to drain from
inside the cylinder.
6. troubLeshootinG
symptom
Air Jack will not lift load
Air Jack will not hold load
Air Jack does not lift smoothly
environmental protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMportant: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
possible causes
inadequate air supply
overload condition
Air line leaks
locking pin not engaged
cylinder requires lubrication
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7AR
Original Language Version
Corrective Action
ensure adequate air supply
use larger capacity jack
locate and seal leaks
engage locking pin
lubricate cylinder wall
01284 757500
01284 703534
AJs10000 | issue 1 19/07/16
fig.3
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
