Advertisement
Functional parts of the device
1
8
9
10
11
12
13
14
15
16
1. Keyboard case
2. Numeric keypad
3. Keyboard case, rear view
4. Tamper contact
5. Batteries
6. On/Off switch
7. Keypad plate
8. " Partial Arming" button ("Stay"
or "Night Mode")
9. "Partial Arming" LED indicator
10. "Arming" button
11. "Arming" indicator
12. "Disarming" button
13. "Ready" LED indicator
14. "Info" button with reprogramming capability
15 "Info" LED indicator
16. "Cancel" button
17. "OK" button - additional actions
Indication
Disarmed - "Arming"
and "Partial Arming"
switched off
"Stay" armed - "Partial Arming"
Arming - "Arming"
indicator is on
Entry delay - "Ready"
indicator flashes green, keypad emits short
beeps
Not ready for arming - "Ready"
Ready for arming - "Ready"
Exit delay - "Ready"
indicator flashes green, keypad emits short beeps
Alarm - "Arming"
and "Partial Arming"
User is authorized, there are troubles - "Info"
User not authorized yet - "Info"
Switching on and off
Set switch 6 to "ON" to turn on the device. If the device is registered in
MAKS PRO, it switches to standby mode. If the device has not been
registered, it will go into sleep mode after 30 seconds.
To turn off the device, set switch 6 to "OFF"
Battery replacement
1. Use a plastic card to remove the device from the mount
2. Pull out and replace the batteries
3. Place the keypad on the back plate and slide it down until it locks
2
7
3
17
4
5
indicators are
indicator is red
indicator is orange
indicator is green
indicators flash red
indicator is yellow
indicator flashes yellow
Installation and connection
Before installing the MAKS Keypad mini, register it with MAKS PRO and
test the keyboard signal level using the MAKS SETUP app.
We recommend to install the keypad in the following order:
1. Selecting the installation location with the best signal
2. Installation of the back plate
3. Keypad installation
Selecting the installation location
Carefully select the installation location for the MAKS Keypad mini.
The device cannot be placed:
1. Outdoors or in areas with unacceptable humidity and temperature
2. In places with a high level of radio interference
3. Near objects that can cause radio signal attenuation or shield-
ing (metal, mirrors, etc.)
4. At a distance of less than 1 m from the security center
Keypad installation
6
1. Use a plastic card to remove
the device from the plate
2. Insert the card into the slot
3. Press down on the fixation
elements with the card
4. Move the keypad up
5. Remove the MAKS Keypad mini
from the back plate
6. Fit the rear plate 7 using the
supplied screws and wall plugs.
7. Place the device on the rear plate 7
and slide it down to fix it and lock
the tamper contact 4. Flashes on indicator 15
will confirm that the tamper is locked
Registration and setup
1. Place the detector at a distance of no more than 2 m from the MAKS
PRO security center. Registration is run at on lowest possible power to
avoid the influence of neighboring systems, which can be being set up
nearby
2. Run the MAKS SETUP application
3. Follow the instructions of the application to connect to the MAKS PRO
and start the registration of MAKS wireless devices
4. Turn on the MAKS Keypad mini, after 10-20 seconds it will be registered
5. Set up a new device in your mobile application
WWW.MAKS.SYSTEMS
Advertisement
