Remove The Sd-Board; Remove The Sc-Board; Remove The Ss-Board; Remove The Stand Bracket - Panasonic TC-P55ST30 Service Manual

9.10. Remove the SD-Board

1. Disconnect the flexible cables (SD1, SD2, SD3, SD4 and
SD5) connected to the SD-Board.
2. Disconnect the flexible cable (SU11-SD11) and the bridge
connectors (SC42-SD42 and SC46-SD46).
3. Remove the screws (×2
Board.

9.11. Remove the SC-Board

1. Remove the SU-Board and SD-Board. (See section 9.9.
and 9.10.)
2. Disconnect the connector (SC2).
3. Disconnect the flexible cable (SC20).
4. Remove the screws (×7
, ×2
) and remove the SD-
) and remove the SC-Board.

9.12. Remove the SS-Board

1. Remove the Tuner unit. (See section 9.5.)
2. Disconnect the connector (SS11).
3. Disconnect the flexible cable (SS33).
4. Disconnect the flexible cables (SS53, SS54 and SS56).
5. Remove the screws (×7

9.13. Remove the Stand bracket

1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the AC inlet. (See section 9.2.)
3. Remove the Stand bracket fastening screws (×10
) and the Stand bracket.
25
) and remove the SS-Board.
, ×4