National Vora Assembly Instruction

Place seat assembly upside down on an elevated flat surface. Position swivel
1
tilt control mechanism on bottom side of seat assembly to match the inside
4-hole configuration. Note: The swivel tilt control adjustment knob is to be
positioned toward the front of the seat. The front of the seat is identified by
the front asset label. Using the 5mm Hex Key Wrench, secure the swivel tilt
control mechanism to the seat assembly using four 5/16-18 x 1" hex head
bolts. Figure A.
Position the right and left arm assemblies on the bottom of the seat as shown
2
in Figure B. Note: To assure proper assembly of the right and left arms, each
arm should angle toward the front of the seat, not rearward. Using the 5mm
hex key wrench, secure each arm with three 5/16-18 x 1 1/4" truss head bolts.
Position the back assembly to the corresponding hole configuration on the
3
back bottom of the seat assembly. Using the 5mm hex key wrench, secure
the back assembly with four
5/16-18 x 1 1/4" hex head bolts. Figure C.
Figure B
Front of Seat
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Figure A
Front of Seat
Vora™ Assembly Instruc on
Figure C
800.482.1717
Product Line
Vora™ Task Chair
Required Tools
• 5mm Hex Key Wrench
(Included)
Package Contents
• Back assembly
• Plastic base
• Gas lift cylinder
• Seat assembly
• Hardware Kit:
• 5/16-18 X 1" hex
head bolts
5/16-18 X 1 1/4"
•
truss head bolts
5/16-18 X 1 1/4"
•
hex head bolts
• Hex Key Wrench
Right arm assembly
•
Left arm assembly
•
Swivel tilt control
•
mechanism
Set of five casters
•
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part # 3215490
Rev, -
Printed in U.S.A
© 2013 Kimball International, Inc.
.
Qty.
1
1
1
1
4
6
4
1
1
1
1
1