National Vora Assembly Instruction

Place seat assembly upside down on an elevated flat surface. Position
1
knee tilt control mechanism on bottom side of seat assembly to match
the outside 4-hole configuration. Note: The knee tilt control adjustment
knob is to be positioned toward the front of the seat. The front of the
seat is identified by the front asset label. Using the 5mm Hex Key
Wrench, secure the knee tilt control mechanism to the seat assembly
using four 5/16-18 x 1" hex head bolts. Figure A.
Position the right and left arm assemblies on the bottom of the seat as
2
shown in Figure B. Note: To assure proper assembly of the right and left
arms, each arm should angle toward the front of the seat, not rearward.
Using the 5mm hex key wrench, secure each arm with three 5/16-18 x 1
1/4" truss head bolts.
3
Position the back assembly to the corresponding hole configuration on the
back bottom of the seat assembly. Using the 5mm hex key wrench, secure
the back assembly with four
5/16-18 x 1 1/4" hex head bolts. Figure C.
Figure B
Front of Seat
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Figure A
Front of Seat
Vora™ Assembly Instruc on
Figure C
800.482.1717
Product Line
Vora™ Task Chair
Required Tools
• 5mm Hex Key Wrench
(Included)
Package Contents
• Back assembly
• Plastic base
• Gas lift cylinder
• Seat assembly
• Hardware Kit:
• 5/16-18 X 1" hex
head bolts
5/16-18 X 1 1/4"
•
truss head bolts
5/16-18 X 1 1/4"
•
hex head bolts
• Hex Key Wrench
Right arm assembly
•
Left arm assembly
•
Knee tilt control
•
mechanism
Set of five casters
•
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part # 3215491
Rev, -
Printed in U.S.A
© 2013 Kimball International, Inc.
.
Qty.
1
1
1
1
4
6
4
1
1
1
1
1