Advertisement
CARTS AND WAGONS
ASSEMBLY
1.
Place the tub on its side on a flat surface.
2.
Remove the nuts and bolts from the axle support,
position the support on the bottom of the tub, and insert
all the mounting bolts, except the two (2) in the back
corners. Install the nuts and washers and tighten nuts.
NOTE: Place all bolts through the dump cart tub with
their heads to the inside of the tub. Nuts are on the
outside (or underside) of the tub.
3.
Attach a leg using one bolt remaining from the previous
step and two (2) bolts (included with the leg). Insert the
leg bolts through the back of the tub, install washers
and nuts, and tighten to secure the leg.
4.
Repeat the step to attach the remaining leg.
Visit www.FarmTek.com for additional products and customer assistance.
5.
Unwrap the axle, set the washers and cotter pins
aside (if needed), and insert the axle through the tubes
welded to the axle support. Center the axle in the axle
support.
6.
Place a wheel onto the axle with its valve stem toward
the outside.
7.
Install a washer on the axle and insert a cotter pin
through the hole in the end of the axle.
8.
Using pliers, spread the ends of the cotter pin to
prevent it from falling out.
Cotter Pin
9.
Repeat the above steps to install the remaining wheel,
washer, and cotter pin.
Washer
Advertisement
