Cobra microTALK MT 925 PRO Manual page 12

MODE FUNCTIONS
To Scan Memory Locations:
1. Press the MODE button until the Scan icon, the Memory icon and
the memory location number flash on the display.
2. Press the CHANNEL UP or CHANNEL DOWN button to begin scanning
memory locations.
The Scan icon and the Memory icon will continue to be displayed when
Memory Location Scan is On. Your radio will continue to scan memory
locations and stop if an incoming transmission is detected. Your radio
will remain on that memory location for ten (10) seconds.
While setting Memory Location Scan, if you do not press any buttons
for fifteen (15) seconds your radio will automatically return to
LISTENING MODE on the channel/privacy code or channel/DCS code
displayed before you entered Mode Functions.
During An Incoming Transmission,
You Can Choose From The Following:
a. Press and hold the TALK button to communicate on that memory location. Your radio
will remain on that memory location and return to LISTENING MODE.
b. Press the CHANNEL UP or CHANNEL DOWN button to resume scanning memory
locations.
If you press the TALK button while scanning and not within ten (10) seconds of receiving a
transmission, you will transmit on the memory location on which, during scanning, you last
received a transmission. This will return the radio to LISTENING MODE.
If you do not press any button within ten (10) seconds, your radio will automatically
resume scanning memory locations.
During Scanning (while not receiving a transmission),
You Can Choose From The Following:
a. Press and hold the TALK button to communicate on either the channel/privacy code
or channel/DCS code that was displayed before you entered Mode Functions or
memory location on which, during scanning, you last received a transmission. This
will return the radio to LISTENING MODE.
b. Press the MODE button to proceed to other functions.
c. Press the ENTER button to return to LISTENING MODE on either the channel/privacy
code or channel/DCS code that was displayed before you entered Mode Functions or
the memory location on which, during scanning, you last received a transmission.
To reduce the number of memory locations being scanned, you may "un-program" any
unwanted locations (see "10 Memory Locations" for further details).
VibrAlert and Call Tones
®
Your microTALK radio can alert you to incoming signals by sounding an audible call tone,
®
by vibrating silently, or both.
Call Alert Icon
VibrAlert & Call
®
Alert Icon
VibrAlert ® Icon
To Change Call Settings:
1. Press the MODE button until the Call Setting icon
flashes on the display. The current setting ("01"
– Vibrate + Ring, "02" – Vibrate Only, or "00"
– Ring Only) is displayed.
2. Press the CHANNEL UP or CHANNEL DOWN
button to change the call setting.
3. When your desired call setting is displayed,
choose one of the following:
a. Press the MODE button to enter the setting
and proceed to other functions.
b. Press the ENTER button to enter the setting and return to
LISTENING MODE.
c. Do not press any buttons for fifteen (15) seconds to enter the
setting and return to LISTENING MODE.
English
Mode Button
Select Scan
Memory Locations
Channel Buttons
Mode Button
Channel Buttons