Advertisement
Quick Links
The safe is equipped with an emergency lock with 2 keys.
Store the keys in a safe place, but never inside the safe itself.
The safe is supplied with the door open and free of fingerprints stored, so any fingerprint can make the
opening until you proceed to store the fingerprint personal.
1. INSTALLING THE BATTERIES
Open the door, with a screwdriver, unscrew the screw of the battery compartment and insert 4 x 1.5V
alkaline batteries "AA" making sure you have complied with the polarity insertion of the batteries (+ and -).
Replace the battery cover with the lid and screw the screw.
2. TEST OPENING FOR A NEW SAFE
Warning: store the keys in a safe place, but never inside the safe itself.
A. Closing the safe:
Place a finger in the fingerprint reader keeping still in the same position until you have a confirmation
beep and the green LED. The door will close automatically.
B. Opening the safe :
Place a finger in the fingerprint reader keeping still in the same position until you have a confirmation
beep and the green LED. The door will open automatically.
3. PROGRAMMING THE PERSONAL FINGERPRINT
The safe is in Factory Default mode and can be opened by any fingerprints. Only successful
registered fingerprint can terminate Factory Default mode.
During registration, the door must remain open and the Bolts must be in the retracted position , or the
fingerprint will not be saved.
A. With the door open and the bolts retracted press the red programming button placed in the internal
part of the lock (see fig. 1).It will light a steady red light and the fingerprint reader is ready to be used.
B. Within 5 seconds, put your finger on the reader keeping still in the same position until you have three
long confirmation beep and the green LED. The storage of the fingerprint has been successful.
C. In the event that the procedure has not been successful, the lock will beep followed by a flashing red
LED. It will be necessary, repeat the operation from point A.
D. To register another fingerprint , please repeat operation A and B
The fingerprint reader can store up to 30 different fingerprints.
RED
PROGRAMMING
BUTTON
INSTRUCTIONS FOR BIOMETRIC SAFES
Mod. FPP/3 Fingerprint
IMPORTANT INFORMATIONI!
Fig.1
Advertisement
Summary of Contents for Technomax FPP/3
- Page 1 INSTRUCTIONS FOR BIOMETRIC SAFES Mod. FPP/3 Fingerprint IMPORTANT INFORMATIONI! The safe is equipped with an emergency lock with 2 keys. Store the keys in a safe place, but never inside the safe itself. The safe is supplied with the door open and free of fingerprints stored, so any fingerprint can make the opening until you proceed to store the fingerprint personal.
- Page 2 IMPORTANT: We also suggest two or more fingers are programmed in case one finger is injured by accident. To avoid fingerprint read failure, we recommend cleaning fingers before placing on the glass panel. Keep glass panel clean and free from grease and moisture. ...
- Page 3 6. RESETTING THE SAFE ATTENTION! This operation permanently erases all stored fingerprints. With the door open and the bolts indented, with a screwdriver, unscrew the screw of the battery compartment and remove the 4 batteries, Press and hold the red button programming until the end of the following procedure: Insert the 4 batteries making sure to have respected the polarity insertion.