Bosch 22612 Operating/Safety Instructions Manual page 11

BM 2609140358 12-05
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use.
To open clip, squeeze both release buttons
and the clip will spring up automatically
(Fig. 4). To use clip, turn tool upside down and
attach to your belt.
SWIVEL LIGHTING SYSTEM
Your tool is equipped with integrated light
source in the knurled thumbwheel. The light
will go ON as soon as you squeeze trigger
switch, unless the thumbwheel is in the 0
position (Fig. 5).
The light beam can be adjusted to 3 positions
in front of the chuck for the desired bit being
used.
Position 1: The focus of the beam is
approximately 20 mm.
Position 2: The focus of the beam is
approximately 150 mm.
Position 3: The focus of the beam is
approximately 500 mm.
Position 0: The beam is shut off permanently.
ATTACHING GEAR BOX COVER
(Models 22618 & 23618 only)
1. Remove rubber guard by pulling forward
(Fig. 6).
FIG. 6
RUBBER
GUARD
12/6/05 3:28 PM
FIG. 7
GEAR BOX
COVER
Page 11
To retract clip when not in use, push down on
clip until it locks in the closed position.
FIG. 5
2. Slide gear box cover into place (Fig. 7).
3. Replace rubber guard to secure gear box
cover (Fig. 8).
FIG. 8
RUBBER
GUARD
-11-
CLIP
FIG. 4
RELEASE
BUTTONS
FIG. 9