Panasonic CF-19 Series Supplementary Instructions Manual page 4

Precautions
For U.S.A.
Federal Communications Commission Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the re-
ceiver is connected.
Consult the Panasonic Service Center or an experienced radio/TV technician for help.
Warning
To assure continued compliance, use only shielded interface cables when connecting to a
computer or peripheral. Also, any changes or modifi cations not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment.
FCC RF Exposure Warning:
This equipment is provided with PC Card slot that could be used with wireless trans-
mitters, which will be specifi cally recommended when they become available. Other
third-party wireless transmitters have not been RF exposure evaluated for use with this
computer and may not comply with FCC RF exposure requirements.
This equipment complies with FCC radiation exposure limits set forth for an uncon-
trolled environment.
CF-19 series
This equipment has been approved for portable operation, and if provided with wire-
less WAN transmitter, requires LCD side panel spacers to provide minimum 1.5 cm
spacing between antenna located within the LCD side panel, and all person's body (ex-
cluding extremities of hands, wrist and feet) during wireless modes of operation.
CF-30 series
This equipment has been approved for mobile operation, and unless otherwise advised
in separate supplemental instructions for individual wireless transmitter(s), requires
minimum 20 cm spacing be provided between antenna(s) and all person's body (ex-
cluding extremities of hands, wrist and feet) during wireless modes of operation.
4