Livid Fader Box Building Manual page 4

3) Populate Header ​ C apacitor ( ​ 1 0uf Capacitor): ​ O n the Omni Board, l ​ o cate HC9 ​ ( HC
denotes "header ​ c apacitor ​ " ), and ​ p opulate with through hole 10uf capacitor. This capacitor
is polarized so be sure the longer leg of the ​ c apacitor ​ is in the through hole marked
positive (+).
4) Populate Wires: ​ On the Omni Board locate the white rectangle labeled
"SLIDE-8X30MM" on the bottom of the board. Within this rectangle are 10 through holes.
Take the 4" wires previously prepared and solder 1 wire into each hole. Make sure that the
wires are coming out of the bottom of the board.