Adjusting The Scanner - CAB CC2 Operator's Manual

2 Installation
2.3

Adjusting the Scanner

1
2
Figure 2 Adjusting distance and angle
In order to adapt the code checker to the code to be checked the scanner may be adjusted :
i
Notice!
If the device was factory-adjusted the adjustment parameters can be found in the test record.
Adjusting the reading distance
• Adaptation to size and resolution of the code
 Loosen knurled screw (2).
 Move the upper part of the retainer (1) with scanner.
 Tighten knurled screw (2).
Adjusting the reading angle
• Adaptation to the position of small codes on the label
 Loosen knurled screw (3).
 Turn the scanner (4).
 Tighten knurled screw (3).
i
Notice!
The moment of checking during the label feed can be set in the software.  Programming Manual.
3
4
7