Match the water temperature to the
type of fabric and soils being washed.
The top temperature
is the wash
selection and the bottom temperature
is the rinse selection.
NOTE: Use warm water with the
PRESS or SHORT
For heavily soiled permanent press
or knit clothes, pre-wash or presoak
before washing in warm water.
3. Select cycle and wash time
Start the washer
Push in the Cycle Control Knob and
turn it clockwise.
Stop when the indicator on the knob's
outer ring points to the number in the
wash cycle you want. The numbers
are minutes of wash time.
Start the washer by pulling out the
Cycle Control Knob. The washer will
fill to the selected water level with the
selected wash water temperature.
After filling, the washer will agitate for
the selected number of minutes.
To stop the washer at any time,
push in the Cycle Control Knob. To
restart the washer, pull out the
Cycle Control Knob.
What happens in each cycle
Each cycle has been designed for dif-
ferent kinds of fabrics. Numbers on the
dial in each cycle are the minutes of
WASH agitation time.
When the Cycle Control Knob is set
to a number and pulled out, the washer
fills before agitation and timing starts.
After agitation starts, the knob turns
clockwise until it points to OFF and the
The washer will pause briefly
through-out each cycle. These pauses
are normal. They allow for the reversing
of the motor, normal washer operation
and the cool-down portion of the