Related Manuals for Stafer 595.K.RS.00
Summary of Contents for Stafer 595.K.RS.00
- Page 1 USER AND MAINTENANCE MANUAL: Radio-controlled sun/wind anemometer for 1 or 2 motors 595.K.RS.00 recycled paper version 2.0...
- Page 2 Stafer S.p.A. declines all liability for damage incurred due to weather events not detected by the device. Any other use beyond the field defined by Stafer S.p.A. is prohibited and involves, as well as the failure to comply with instructions provided in this guide, voidance of Stafer S.p.A.'s liability and warranty.
- Page 3 02. ASSEMBLY INSTRUCTIONS 02.1 LED DIAGRAM Components key: Green (1) Impeller (2) Anemometer body (3) Support fastening screw Yellow (4) Wall fastening support (5) Rubber cable entry 02.2 FASTENING SYSTEMS 02.3 ASSEMBLY INSTRUCTIONS The anemometer is normally supplied already wired. If not, follow the instructions below. Unscrew the 3 Punch the rubber Connect the cable to the...
-
Page 4: Motor Connection
Below is the combination of colored cables with the corresponding controls. 1 MOTOR CONNECTION MECHANICAL MOTOR 1 ANEMOMETER TERMINAL BOARD maneuver maneuver blue yellow/green BUTTON 1 down blue MAIN POWER SUPPLY 2 MOTORS CONNECTION MECHANICAL MECHANICAL MOTOR 1 MOTOR 1 ANEMOMETER TERMINAL BOARD maneuver... - Page 5 04. INTERFACING WITH HOME AUTOMATION CONTROL UNITS ü This device can be interfaced to the most widespread home automation control units through the wires of the command buttons (it is still necessary to check beforehand the compatibility, assessing whether the home automation control unit is able to provide appropriate signals to the device). ü...
- Page 6 06. HOW TO ADD OR REMOVE A REMOTE CONTROL After having stored one or more remote controls, it is possible to add other ones by “cloning” the functioning remote controls. It is also possible to eliminate an already stored and functioning remote control. Proceed as follows. 06.1 USING THE REMOTE CONTROL (Only if a remote control is already stored) 01.
- Page 7 08. SUN FUNCTION The “sun” function allows the awning to move automatically according to sun exposure, based on brightness measured by the light sensor installed on the anemometer. This function is deactivated by default and can be activated at a later time. If the intensity of the sun is above the set threshold for at least 2 minutes, an automatic downward manoeuvre is performed;...
- Page 8 10. OPERATING LOGIC OF COMMAND BUTTONS This device provides the possibility to choose one of the following operating logics for the command buttons: “Pulse” logic This is the default mode from the factory. The motor moves up (down) if the relevant contact is closed on phase for at least 0.5 sec, the motor will stop if any one of the two contacts is closed briefly (less than 0.5 sec).
- Page 9 All products and technical specifications given in this document are subject to variation without prior notice. Unless previously and specifically authorised by STAFER, the device must be used exclusively with transmitters produced by STAFER. STAFER cannot be considered responsible for damage caused by improper, incorrect or unreasonable uses.
Need help?
Do you have a question about the 595.K.RS.00 and is the answer not in the manual?
Questions and answers