Stafer 595.K.F2.00 User And Maintenance Manual

Sun/wind anemometer for 1 or 2 motor

Advertisement

Quick Links

www.stafer.com
USER AND MAINTENANCE MANUAL:
Sun/wind anemometer for 1 or 2 motors
ENG
595.K.F2.00
recycled paper
version 1.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 595.K.F2.00 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Stafer 595.K.F2.00

  • Page 1 USER AND MAINTENANCE MANUAL: Sun/wind anemometer for 1 or 2 motors 595.K.F2.00 recycled paper version 1.0...
  • Page 2 Any other use beyond the field defined by Stafer S.p.A. is prohibited and involves, as well as the failure to comply with instructions provided in this guide, voidance of Stafer S.p.A.'s liability and warranty.
  • Page 3 02. ASSEMBLY INSTRUCTIONS 02.1 LED DIAGRAM Components key: Yellow (1) Impeller (2) Anemometer body (3) Support fastening screw Green (4) Wall fastening support (5) Rubber cable entry 02.2 FASTENING SYSTEMS 02.3 ASSEMBLY INSTRUCTIONS Unscrew the 3 screws and open the Punch the rubber cable entry and Connect the cable to the terminals upper case.
  • Page 4 03. ELECTRICAL CONNECTION ü Make all connections with the power supply disconnected. ü Check that the power line does not feed on electrical circuits to be used for lighting. ü Always connect the motor to the grounding system (yellow/green). ü The power line must be equipped with a magnetothermal or differential circuit breaker.
  • Page 5 04. INTERFACING WITH HOME AUTOMATION CONTROL UNITS ü This device can be interfaced to the most widespread home automation control units through the wires of the command buttons (it is still necessary to check beforehand the compatibility, assessing whether the home automation control unit is able to provide appropriate signals to the device). ü...
  • Page 6 06. SUN FUNCTION The “sun” function allows the awning to move automatically according to sun exposure, based on brightness measured by the light sensor installed on the anemometer. This function is deactivated by default and can be activated at a later time. If the intensity of the sun is above the set threshold for at least 2 minutes, an automatic downward manoeuvre is performed;...
  • Page 7 07. AUTOMATIC LOWERING FUNCTION AFTER WIND ALARM This device allows lowering the awning automatically after it retracted due to a wind alarm. After 5 minutes without wind, either of two situations can occur: - If the sun sensor was activated, it will re-open the awning only if the awning was open when the wind was detected (if it was already closed, it will remain closed).
  • Page 8 All products and technical specifications given in this document are subject to variation without prior notice. Unless previously and specifically authorised by STAFER, the device must be used exclusively with transmitters produced by STAFER. STAFER cannot be considered responsible for damage caused by improper, incorrect or unreasonable uses.

Table of Contents