Table of Contents
Advertisement
Pentair Cleanload chemical eductors are designed to mix fluids and dry chemicals in a self-contained system. The inline
eduction system allows the operator to mix chemicals quickly and safely. The Cleanload operates by receiving a fluid into
the eductor where a fluid or dry chemical is mixed in. The mixture is then transferred into a holding tank to be used for
spraying crops. Construction features a polypropylene venturi eductor and polyethylene hopper tank and FKM gaskets.
The Cleanload is designed and constructed for incorporation into a large variety of applications that require the mixing
of liquid and dry chemicals. All other uses are to be considered misuses unless approved by the manufacturer. The
Cleanload can be used in a wide variety of conditions including:
• Fluid temperatures ranging from 1 to 49°C (34 to 120°F).
• The Cleanload must only be used in outdoor or well-ventilated areas.
Hypro has provided this manual to provide instructions and requirements that must be met when installing, using and
maintaining the product(s) included in this document.
If the product is sold, the seller must pass this manual on to the new owner.
The following special attention notices are used to notify and advise the user of this product of procedures that may be
dangerous to the user or result in damage to the product.
Attention is used to notify of installation, operation, or maintenance information that is important but not safety related.
This symbol is used to denote the presence of an electrical hazard that will result in personal injury, death or property
damage.
This symbol is used to denote the presence of a hazard that will result in personal injury, death or property damage.
California Proposition 65 Warning -- This product and related accessories contain chemicals known to the
State of California to cause cancer, birth defects or other reproductive harm.
Hypro Cleanload are designed to operate effectively within the pressure and environmental ranges. Going outside of
these ranges will void the warranty and could cause damage to property, serious injury or death.
•
DO NOT use the Cleanload in a potentially explosive environment.
•
DO NOT use the Cleanload without the hopper cover securely attached.
•
DO NOT operate the Cleanload with missing, damaged, or leaking parts. Inspect for damaged parts prior to
each use.
•
DO NOT use the Cleanload in drinking water or any other system producing products for human
consumption.
•
DO NOT use the Cleanload without the proper person protection equipment.
•
DO NOT use the Cleanload if it is not properly secured into position.
•
DO NOT exceed the maximum pressure when using the Cleanload.
•
DO NOT use the Cleanload in wind exceeding 10 MPH.
Introduction
Description
Intended Uses
Purpose of Manual
ATTENTION
Misuses
- 3 -
Advertisement
Table of Contents
