Starting Up The Unit; Switching The Speaker Mode - Pioneer DMH-Z5350BT Operation Manual

• Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator.

Starting up the unit

1
Start the engine to boot up the system.
The [Select Program Language] screen appears.
NOTE
From the second time on, the screen shown will differ depending on the previous conditions.
2
Touch the language.
3
Touch .
The [Speaker Mode Settings] screen appears.
4
Touch the speaker modes.
[Standard Mode]
4-speaker system with front and rear speakers, or a 6-speaker system with front and
rear speakers and subwoofers.
[Network Mode]
3-way system with a high range speaker, middle range speaker and subwoofer (low
range speaker) for reproduction of high, middle and low frequencies (bands).
WARNING
Do not use the unit in Standard Mode when a speaker system for 3-way Network Mode is
connected to the unit. This may cause damage to the speakers.
5
Touch [OK].
Initial Legal Disclaimer screen appears.
6
Touch [OK].
The top menu screen appears.
NOTE
Once the speaker mode is set, the setting cannot be changed unless this product is restored to the
default settings. Restore the default settings to change the speaker mode setting (page 79).

Switching the speaker mode

To change the speaker mode, you need to restore this product to the default settings.
1
Restore the default setting (page 79).
- 12 -