Advertisement
CONFERENCE TABLE WITH CURVED BASE
Illustration 2
End of stretcher
Curved base
panel
Stretcher
Top
Illustration 2
Curved base
panel
Top
60181252B
SIDE 2 OF 2 (2/07)
Curved base panel
Wedge washer
Glide
Glide insert
Read all instructions and review illustrations
before installing.
Tools required for assembly:
/
" socket
1
2
Socket wrench
Washer
1
/
" bolt
This assembly includes:
2
(1) Top
(2) Curved base panels
(8)
/
" bolt
1
2
(8)
/
" washer
3
8
(8) Wedge washer
(4) Glide insert
(4) Glide
To prevent the possibility of serious eye
injury, always wear eye protection when
using power tools.
Heavy panels can pinch or crush fingers.
Do not place fingers between or under
panels during assembly.
Installation:
1. Refer to Illustration 1. Lay top, with stretchers
facing up, on cardboard or a carpeted sur-
face.
2. Refer to Illustration 1. Position curve panels
against stretchers and align pre-drilled holes
in base panel with holes in ends of each
stretcher.
3. Place a washer (from hardware pack) and
wedge washer (from hardware pack) onto
each
/
" bolt (from hardware pack). I
1
2
Install a bolt (with washer and wedge wash-
er) through each hole in base panel (four per
panel) and into ends of stretcher. Use the
socket and wrench to fully tighten bolts.
4. Refer to Illustration 2. Thread a glide (from
hardware pack) into each glide insert (from
hardware pack) by turning glide clockwise
until glide is flat against insert.
Locate two holes in bottom of each base
panel. Use the rubber mallet to install a
glide/glide insert assembly into each hole.
5. Use two or more people to set table upright
and to position table were desired.
Adjust glides until table is level from front-to-
rear and side-to-side. Use the 24" long level
to verify table is level.
Rubber mallet
24" long level
WARNING
/
"
1
2
Advertisement
