Table of Contents
Advertisement
if the cable or plug is damaged during use, switch the electricity supply off and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) connect the Green/yelloW earth wire to the earth terminal 'e'.
b) connect the broWn live wire to the live terminal 'l'.
c) connect the blue neutral wire to the neutral terminal 'n'.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.3.
General saFety
WarnInG! disconnect the heater from the mains power supply before carrying out any servicing or maintenance.
‰
Maintain the heater in good order and clean condition for best and safest performance. replace or repair damaged parts.
9
locate heater in a suitable work area and keep area clean, tidy and free from unrelated materials. ensure there is adequate lighting
9
and keep the immediate area in front of the outlet grille clear.
allow the unit to cool before storage. When not in use, disconnect from the mains power supply and store in a safe, cool, dry,
9
childproof area.
only use the heater standing in the upright position on a level surface.
9
dO nOt use the heater where there are flammable liquids, solids or gases such as petrol, solvents, aerosols etc, or where heat
8
sensitive materials may be stored.
dO nOt place the heater near items that may be damaged by heat, allow at least 2mtr clearance in front of the heater.
8
dO nOt allow the heater to get wet as this may cause an electric shock, causing damage to the heater and possible personal
8
injury.
dO nOt let power lead hang over an edge (i.e. table), or touch a hot surface, lie in the beam of heat, or run under a carpet.
8
dO nOt use in bathroom, shower room, or in any wet or damp environments or where there is high condensation.
8
dO nOt operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
dO nOt insert or allow objects to enter any openings of heater as this may cause an electric shock, fire or damage to heater.
8
dO nOt use heater if the power cord, plug or the heater is damaged, or if the heater has become wet.
8
dO nOt use the heater for any purpose other than for which it is designed.
8
dO nOt use a timer or other remote device to operate the heater.
8
dO nOt allow children to touch or to operate the heater.
8
dO nOt site the heater below an electrical socket outlet.
8
dO nOt use the heater without the grille fitted.
8
dO nOt use the heater out of doors. these heaters are designed for indoor use only.
8
dO nOt cover heater when in use, and dO nOt obstruct the air inlet and outlet grilles.
8
dO nOt place heater too close to yourself or any object, allow the air to circulate freely.
8
dO nOt touch the outlet grille of the heater during and immediately after use as it will be hot.
8
1.4.
OPeratIOnal PreCautIOns
the heater must only be used by people who have read these instructions and have been trained in its use.
9
dO nOt obstruct the air inlet and outlet sections of the heater.
8
dO nOt cover the heater.
8
dO nOt touch the heater casing or grille when first switched off, as these will be very hot and will take time to cool.
8
this appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. children shall not play with the appliance. cleaning and
user maintenance shall not be made by children without supervision.
children of less than 3 years should be kept away unless continuously supervised.
children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed
in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
CautIOn some parts of this product can become very hot and cause burns. particular attention has to be given where children
and vulnerable people are present.
2. IntrOduCtIOn
electric fan heaters with ducting for industrial applications. Model no. deh2001 features one heat setting, Model nos. deh3001, deh5001
and deh10001 feature two heat settings. all units have thermostat control and fan only options. a totally dry heat with no condensation, no
gas, no fumes and no smell. ideal for workshops and garages. Model no. deh2001 is supplied with 6m ducting hose, power cable and 3-pin
plug. Model no deh3001 is supplied with 6m ducting hose and power cable. deh5001 is supplied with 6m ducting hose, 3ph power cable
and 16a plug. deh10001 is supplied with 6m ducting hose, 3ph power cable and 32a plug.
3. sPeCIFICatIOn
Model no: .................................deH2001 ........................... deH3001 ........................... deH5001 .............................. deH10001
power: ...........................................2000W ............................... 3000W ................................5000W .................................. 10000W
supply: ................................... 230V - 13a .........................230V - 16a .................. 415V/3ph - 16a ....................... 415V/3ph - 32a
4. COnneCtIOn (deH10001)
4.1.
COnneCtInG deH10001 tO MaIns suPPly see fig.1
4.1.1.
the deh10001 heater is supplied with a protected 5 pin connector mounted on the side of the control housing. in order to connect
to the mains it will be necessary to have the extension cable shown in fig.1 made up by a qualified electrician. (this connector is
not supplied with the machine.) the cable should be no shorter than 1.8mtr and no longer than 3.0mtr.
4.1.2.
before connecting the deh10001 to the mains ensure that the selector switch is set to off and the thermostat is set at minimum.
4.1.3.
hold open the protective cover on the socket connector on the extension lead as shown above and present it to the heater
connector in the correct orientation so that the spigot on the heater connector passes into the keyway on the socket connector.
push the socket connector fully home.
© Jack sealey limited
Original Language Version
deh2001 deh3001 deh5001 deh10001 issue 1 23/08/19
Advertisement
Table of Contents
