Page 1
Wheel Hoe (PW105) The following instructions were provided by the manufacturer. Assembly Instructions Your package should contain the following: Components: 1 - Toolbar Assembly with wheel arms attached 1 - Steel Wheel 2 - Steel Dust Caps (For wheel assembly)
Page 2
Materials Required 2 - Steel dust caps 1 - Wheel 1 - Shoulder bolt with nylon lock nut DIRECTIONS: 1) Place dust caps onto each side of the wheel hub 2) Slide wheel into place between wheel arms 3) Place 3/8" shoulder bolt through wheel arms and hub 4) Install 5/16"...
Page 3
Installing Handles and Tapered Dowel Rod Materials Required 2 - Wood Handles 4 - carriage head bolts (1/4" x 1-1/2") 4 - 1/4" flat washer 4 - 1/4" lock washer 4 - 1/4" nut 1 - Tapered Dowel Rod 2 - 1" Wood Screws DIRECTIONS 1) Position handles to the outside of each toolbar handle mount (Use the bottom 2 holes in handle for single wheel hoe)
Page 4
Outfitting your Hoss with sweeps S100 and S101. 1. Remove the cultivator teeth from the host toolbar (keep the bolts and nuts with the teeth) 2. With the special square head bolts inserted from the bottom of the sweep upward and the flanged nut in place, position the flange nut into the quick change hole on the tool bar and slide to the desired position and tighten.