Advertisement
5. The installation must include some form of isolation
switch to allow for future maintenance work.
6. All necessary care should be taken to ensure that
the unit cannot be disconnected accidentally.
7. Once connected to the mains the gas detector needs a
warm-up period of 3-4 minutes, after which the unit will
work.
DO NOT REMOVE THE COVER FROM THE NATURAL GAS
DETECTOR WHEN THE DETECTOR IS CONNECTED TO MAINS
Pairing the Natural Gas Detector to a Tunstall Lifeline.
1. Place the Lifeline home unit into telecare sensor assign
mode by pressing the green cancel button until the unit
beeps and/or announces 'Programming Mode', then
press and hold the green cancel button again until the
unit beeps, release the cancel button and the unit will
announce 'Registration Mode' .
2. Generate a radio transmission from the Natural Gas
Detector by placing the magnet (supplied in the box)
adjacent to the Detector at the point labelled
"MAGNET". The Lifeline will announce "Gas Detector" to
confirm pairing was successful.
D6907021A0
POWER.
3
Advertisement
