Download Print this page

NUKI Bridge Setup Manual

Hide thumbs Also See for Bridge:

NUKI Bridge setup

1. Insert the Nuki Bridge into a power socket near your Smart Lock (max. 5 meters distance).

The Nuki Bridge is then automatically in maintenance mode and ready to be set up with the

Nuki app.

2. Open the menu in the Nuki app (top left) and choose "Manage Bridge" to search for your

Bridge in maintenance mode. During the Bridge setup you can configure the settings of your

Wi-Fi and the developer mode (API).

Note: To use the API you have to enable the developer mode.

Table of Contents

Need help?

Do you have a question about the Bridge and is the answer not in the manual?

Page 1 The Nuki Bridge is then automatically in maintenance mode and ready to be set up with the Nuki app. 2. Open the menu in the Nuki app (top left) and choose “Manage Bridge” to search for your Bridge in maintenance mode. During the Bridge setup you can configure the settings of your Wi-Fi and the developer mode (API).
Page 2 If the pairing between Smart Lock and Bridge did not work, the devices automatically leave the pairing mode after 60 seconds. If the Bridge LED is not flashing for 3 seconds after the pairing, the pairing was not successful. Please try it again and make sure that the Bridge is inserted into a power socket within max.
Page 3 If after a few minutes still no locking commands can be send to your Smart Lock via Bridge, close the Nuki app and open it again to force a status update. If that does not help, check the connection status of your Smart Lock with the Nuki app. To check the connection status of your Smart Lock, tap on the desired Smart Lock in the Nuki app and enter the lock settings.