Vanguard VGFRG-2124-2125BK Installation Instruction

Vanguard VGFRG-2124-2125BK Installation Instruction

Elite modular front runner for toyota tacoma

Advertisement

Quick Links

Thank you very much for choosing our products.
Please read the installation instruction carefully before using our product and be sure to
fully understand the contents mentioned above for subsequent installation.
In addition, please keep properly the installation instruction for product maintenance in
future.
The following symbols are used in this installation instruction.
Non-compliance may cause the problems with vehicle. Please do not install that is not
recorded in this instruction.
lease forgive that we are not responsible for any consequences arising from the
P
installation not according to our installation instruction.
2016-20 Toyota Tacoma
Elite Modular Front Runner
VGFRG-2124-2125BK
Installation Instruction
Attention
Relevant matters must be obeyed for safety.
Non-compliance may result in injury or other accidents.
Please read carefully and obey strictly.
Relevant matters must be obeyed for the smooth installation
and use.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VGFRG-2124-2125BK and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vanguard VGFRG-2124-2125BK

  • Page 1 2016-20 Toyota Tacoma Elite Modular Front Runner VGFRG-2124-2125BK Installation Instruction Thank you very much for choosing our products. Please read the installation instruction carefully before using our product and be sure to fully understand the contents mentioned above for subsequent installation.
  • Page 2 Product Composition *Please confirm if it is missing. A 、 Side bend (2 B 、 Top bend C 、 Middle tube D 、 Sand baffle plate E 、 Sub plate F 、 Mount Bracket pieces) (1 piece) pieces , R 、 L) (...
  • Page 3 Fig1 : Parts assembly I 、 J 、 K M 、 N 、...
  • Page 4 Fig2 : Parts assembly I 、 J 、 Fig3 : Open hood and remove plastic cover to locate cross-support in front of radiator (arrows)
  • Page 5 Fig4: Plastic bumper removed for instruction purposes only-do not remove bumper, Locate the outer holes in the bottom of the radiator cross support (arrow) viewed from below. Fig5:Insert Bolt plate (arrow) into back of radiator cross support and down through hole in bottom (passenger side pictured through bumper)...
  • Page 6 Fig6:Driver side Bolt Plate installed...
  • Page 7 Fig6 : Passenger side Top Support Bracket Fig7 : Passenger side Top Support Bracket installed-pictured from below bumper H 、 J 、 K 、 J 、 K 、 L Fig7 : Installation Instruction...
  • Page 8 I 、 J 、 K 、 Existing factory screw K 、 L 、 P 、 Fig8 : Installation complete...
  • Page 9 TIPS: = Routine Maintenance = 1) Please use neutral detergent to wet the soft cloth or suede and so on, then clean our product.

Table of Contents