Panasonic CF-WGP Series Addendum

This addendum explains the cases where the operation of the computer differs from that in the Operating Instructions and the
Reference Manual.
Read Me First
Add the following to "For Canada".
Industry Canada
This product complies with RSS210 Industry Canada.
Operation is subject to the following two conditions;
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
First-time Operation
Windows XP Add the following to Step 6.
CAUTION
If you have changed the Setup Utility settings, be sure to reset them to the default settings.
Windows 2000 Replace Step 6 with the following.
6
Turn your computer on and run the Setup Utility.
1 Slide the power switch and hold it for approximately one second until the power indicator turns on before releasing it.
2 Press F2 while [Panasonic] boot screen is displayed soon after computer begins the startup procedure.
3 Press F9 . At the confirmation message, select [Yes] and press Enter .
4 Select the [Advanced] menu, then set [GPS] to [Disable]. (If there is a [Wireless Modem] or [CDMA], also set them to
[Disable].)
5 Press F10 . At the confirmation message, select [Yes] and press Enter .
The computer will restart.
CAUTION
Do not slide the power switch and hold it for more than four seconds; this will cause the power to be turned off
forcibly.
Do not slide the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before powering it on again.
Windows 2000
Perform the following after setting up Windows.
Setting up GPS
1
Select [Start]-[Run] and input "c:\util\gps\skipenum.reg", then select [OK].
2
Select [Yes] and select [OK].
3 Restart the computer as follows:
Select [Start] - [Shut Down], and select [Restart], then select [OK].
4 Press F2 while [Panasonic] boot screen is displayed soon after computer begins the startup procedure.
5 Press F9 . At the confirmation message, select [Yes] and press Enter .
6 Press F10 . At the confirmation message, select [Yes] and press Enter .
The computer will restart.
Printed in Japan
Addendum
"OPERATING INSTRUCTIONS"
"OPERATING INSTRUCTIONS"
FJ1103-0
DFQX1481ZA