Advertisement
Available languages
Available languages
FINISH AND CHECK FOR
5.
LEAKS
Note: Any distrtion the hose may
have assumed in packaging will relax
soon after warm water has run through
the hose.
Hang your hand shower on its mount.
Slowly turn on the cold water and
look for leaks. If leaks occur re-tighten
connections in small steps being careful
not to over tighten and strip threads.
Operation and Maintenance
Your shower operation is designed for
optimum performance and still meet
ANSI code A112.18.1M requirements
of 2.5 gallon per minute (9.5 LPM)
maximum flow rate at 20 to 80 PSI for
the preservation of water and energy.
The flow restricter that performs this
function is located in the end of the
hand shower. Removal of this device
will increase your water and energy
consumption.
Impurities in any water system will over
time generally accumulate at the shower
orifice, slowly closing then off.
Cleaning these deposits is best achieved
by washing with a soap solution and
simply adjusting the mechanism which
will flush them out. For calcium deposits,
soaking them in vinegar and then
flushing them usually works.
Clean your shower's finish with warm
sudsy water to avoid destroying your
products finish.
Models with Pause Controls incorporate
a pause in the flow to allow time for other
bathing activities. This is not a shut off
position. A small drip is designed into
the unit to reduce temperature build up
and remind you that the shower is just
paused, not off. To shut it off, use your
shower valve.
OPTIONS TO CONSIDER
Add a hand shower unit -
to a shower head
Keep your existing shower head and ADD
the CONVENIENCE of a hand held shower
unit by inserting a shower arm diverter,
Delta
Model U4923, between the shower
®
head and the shower arm. The diverter
gives you
the choice of
either the hand
shower or the
shower head.
Just a pull on
a knob ot the
turn of a lever
and your water
diverts where you want it. The shower arm
diverter installs easily onto the shower arm
with a gasket and plumber tape the shower
head installs on to the diverter, again with
plumber tape and a gasket. The hand
shower unit's hose attaches to the lower
outlet of the diverter. Only wall mounted
hand shower units will provide a place for
mounting the hand shower.
Adjustable height mounting -
Glide Rail accessory
Your Glide Rail adjustable shower mount is
designed for easy installation using the special
adhesive tape and screws supplied. However,
before you proceed, we recommend you
carefully read
these instructions
to help determine
the best
mounting method
and assure a
satisfactory
installation.
1. SELECT
LOCATION
Select wall
position at
convenient
location suitable
for height of
bathers. Hold the
Glide Rail against
the wall to check height and make sure it is
located to permit full height adjustment with the
4
Advertisement
