Safety Advice; Cleaning Instructions; Before Assembly - Palram Glory 8'x8' Manual

IMPORTANT
Please read these
instructions carefully before you start to assemble this product
.
Please
carry out the
steps in
the order
set
out
in
these instructions.
Keep these instructions in
a
safe place for future reference.
Safety Advice
For safety purposes we
strongly recommend the product to
be assembled by at least
two
people.
Some parts may have sharp edges. Please be
careful when handling components. Always wear
gloves, eye
protection,
and long sleeves
when assembling or performing any maintenance on your
product.
Do
not attempt to
assemble the product
in
windy or wet conditions.
Do
not attempt to
assemble the
product if you
are tired, have taken drugs,
medications or alcohol, or if you
are
prone to dizzy spells.
Dispose
of
all
plastic
bags safely
-
keep them away from children's
reach.
Keep
children away from the assembly
area.
When using
a
stepladder or power tools, make sure
that you
are
following
the manufacturer's safety advice.
Keep roof and gutters clear
of
snow,
dirt
& leaves.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
Do
not
lean
against or push the product during construction.
Hot items such
as
recently
used grills,
blowtorches
etc. must not be
stored inside the product.
Heavy or sharp articles should not
be
leaned against the wall panels.
Make Sure there are no
hidden pipes or cables
in
the ground before inserting the
pegs
(not supplied)
Do
not touch overhead power
cables
with the aluminum profiles.
If
color was scratched during assembly it can be fixed.
Note:This product must
be
anchored on to
a
leveled surface and solid foundation to ensure its
stability.
Make sure
that
screws and anchors are
compatible with foundation type.
Make sure
that there
are no
obstructions between the assembly area and the final position.
Cleaning Instructions
In
order to
clean
the product,
use
a
mild detergent solution and
rinse
with cold clean
water.
Do
not
use
acetone, abrasive cleaners, or other special detergents to clean the
panels.
Clean
the product once assembly
is
complete.
Before Assembly
Choose
your
site
carefully before beginning
assembly.
The ground surface must
be
perfectly flat and leveled.
Choose
a
sunny
area,
away from overhanging
trees.
Do not position your product
in an area
exposed to excessive winds.
The
product must
be
positioned and fixed onto
a
flat leveled
surface.
We
strongly recommend to
secure
this product directly onto
a
solid
foundation.
Use
the pre-drilled
holes in the steel base.
Complete
site
preparation before unpacking parts and beginning
assembly.
Sort the parts and check against the content parts
list.
Parts
should
be laid
out
close at hand. Keep all small parts (screws etc.) in
a
bowl
so
they
do not get
lost.
Please
consult your local authorities if any permits
are
required prior to constructing the
product.
The drawings
in
this manual are designed for 8'
x
8'
product
+ 4' Extension Kit.
Please
note that content
list refers
only for
8' x 8'
product.
Note:
All the extension module steps are marked
with
a
dashed
outline, should
be
performed during the product's assembly
process.