High performance voltage regulator for harley davidson (3 pages)
Summary of Contents for PerTronix Compu-Fire 53730
Page 1
024-53730 INSTALLATION INSTRUCTIONS P/N 53730 & 53735 EZ Fit Starter for 1965-1988 Big Twin Harley Davidson’s® Parts List: (1) Compu-Fire Starter (2) 1/4-20 X 3/4” Socket Head Cap Screw (2) 10-24 X 3/4” Socket Head Cap Screw READ THESE INSTRUCTIONS COMPLETELY BEFORE BEGINNING INSTALLATION! NOTE: Refer to the Factory Shop Manual electrical section for safety instructions prior to preforming any repairs or installations of electrical components.
024-53730 4. Clean the starter gearbox Housing where the starter mounts. Step #2 STARTER INSTALLATION: 5. Loosen the two long mounting bolts on the New Compu-Fire starter and carefully remove the front housing from the starter – CAUTION: Be careful to NOT remove the armature and housing from the rear brush housing of the starter.
Page 3
024-53730 6. Install the Compu-Fire front housing to the starter gearbox on the primary. There are four sets of holes and two sets of screws. Orientate the holes that will allow the starter to be installed with the battery post in the same location as the original starter. Use the supplied screws that match the thread in the starter gearbox on your bike.
Page 4
024-53730 7. Install the starter. Carefully slide the starter into position keeping the armature and housing together with the brush housing. Start the two long bolts and tighten evenly alternating back and forth - torque to 49 in. lbs. DO NOT USE AIR TOOLS ON THESE SCREWS! 8.
If within the period of the foregoing warranty PerTronix finds, after inspection, that the product or any component thereof is defective, PerTronix will, at its option, repair such products or component or replace them with identical...