Install The Handles - Kohler K-T10585 Installation Manual

Handle
Apply plumbers
putty.
Screw
Valve Stem
Brass Spline
Valve Body
Adapter
Threaded
Sleeve
Valve Stem
Height
Measurement

4. Install the Handles

NOTE: There are different handle styles available for this product.
Only one style of handle is shown. Installation of all handle styles is
identical.
Remove the plaster guards.
Measure the distance from the top of the valve stem to the
finished surface.
For a valve stem height between 1-13/16" (4.6 cm) and 2-1/8" (5.4
cm) use a brass spline adapter and screw. For a valve stem height
between 2-1/8" (5.4 cm) and 2-5/16" (5.9 cm) use a plastic spline
adapter.
If the brass spline adapter is required, attach using the screw
supplied. The plastic spline adapter slides on with no attachment.
Position the handle assemblies facing in opposite directions away
from the spout.
NOTE: The spline adapter allows fine adjustment of the handle
alignment. To adjust, remove the handle and reposition the spline
adapter.
Align the handle.
Reinstall the handle and check alignment.
1036164-2-A
Hot
Plastic
Spline
Adapter
Orientation of Handles
in Off Position
Finished
Surface
6
Cold
Kohler Co.