Advertisement
Expanding the battery packs:
The battery packs can be easily expanded by making additional parallel connections across the
battery connection terminals. Up to 3 parallel connections can be made across each positive
and negative set of terminals.
1. Make sure any existing batteries are disconnected/isolated from the inverter/charge
controller.
2. Loosen the cable glands, remove the terminal plate covers and remove any existing
cables/ring terminals from the connection boxes.
3. Using a stepped drill bit, drill an additional hole along one of the free side walls of the
connection boxes which would be 90 degrees to any existing connections. Drill the
correct sized hole so that the new M25 cable glands fit snug.
4. Remove any metal filings from the connection boxes using a pressurised air canister.
5. Create any new connections and restore any existing connections, tighten the
connection terminal screws, restore the plate covers and tighten all cable glands
securely to ensure a water/dust tight finish.
Warranty Coverage:
DCS protects this product under warranty when this product is installed and used as detailed in
this manual. Violating the installation procedure or using this product in any way not
described in this manual immediately voids all warranties on this product.
Limitation of Liability:
DCS does not provide warranty or assume liability for direct or indirect damages or defects
that result from the following causes: Transportation or storage, incorrect installation,
operating the product in an inappropriate environment, incorrect or inappropriate operation,
insufficient ventilation, repairs or modifications performed by unauthorised personnel,
rectifier failure or overcurrent, force majeure events, external influences, such as unusual
physical or electrical stress and use of a rectifier that fails to meet the requirements.
5
Advertisement
