Whirlpool GR556LRKB0 Installation Instructions Manual page 7

6.
Place cardboard or hardboard in
front of range. Stand range back up onto
cardboard or hardboard.
WARNING
Tip Over Hazard
A child or adult can tip the range and
be killed.
Connect anti-tip bracket to rear
range foot.
Reconnect the anti-tip bracket, if the
range is moved.
Failure to follow these instructions can
result in death or serious burns to
children and adults.
7.
Place the anti-tip bracket template
on the floor in the cabinet opening so
that the left edge is against cabinets and
the top edge is against the rear wall,
molding or cabinet. If countertop opening
is deeper than 25 inches (63.5 cm),
measure and mark a distance 25 inches
(63.5 cm) in from front of countertop
opening and align template with mark (or
subtract 25 inches [63.5 cm] from
countertop depth and add the difference
to the 2-1/4-inch [5.7 cm] dimension).
25" (63.5 cm) countertop over
24" (61 cm) cabinet
If countertop is not flush to the side of
cabinet opening, align the left side of the
template to allow for the countertop
overhang. Tape the range anti-tip bracket
template in place.
25" (63.5 cm)
Contact a qualified floor covering
installer for the best procedure of drilling
mounting holes through your type of
floor covering.
8.
To mount anti-tip bracket to wood floor,
use the anti-tip bracket template to mark
where to drill mounting holes. Use a drill
with a 1/8" drill bit to drill the two holes.
Remove template from floor.
To mount anti-tip bracket to concrete or
ceramic floor, use the anti-tip bracket
template to mark where to drill mounting
holes. Use a drill with a 3/16" masonry
drill bit to drill the two holes. Remove
template from floor. Tap plastic anchors
into mounting holes in floor with
slide-in
cutout
hammer.
shown
9.
Line up holes in
anti-tip bracket with holes
anti-tip in floor. Use the screws
bracket
provided to fasten
template
anti-tip bracket to
floor.
NOTE: Anti-tip
bracket must be
mounted securely to
the sub floor. Depending
on the thickness of your flooring,
longer screws may be necessary to
anchor the bracket to the sub floor.
Longer screws are available from your
local hardware store.
A
Countertop
overhangs
cabinet side.
A = Difference
between
countertop depth
and 25" (63.5 cm).
anti-tip
bracket
template
slide-in cutout
shown
10.
Move range close to cabinet
opening. Make electrical connection. See
"Electrical requirements" and "Electrical
connection" sections for details. "8888"
should appear in the clock display. Refer
to Use and Care Guide for information on
electronic controls.
11.
Remove cardboard or hardboard
from under range. Carefully move range
into final position.
12.
The
left rear leveling
leg must be
engaged in the
anti-tip bracket. If
leveling leg is not
properly engaged,
remove and reposition the anti-tip bracket
to ensure that the leveling leg fits
properly in the anti-tip bracket.
13.
Place rack in oven. Place level
on rack, first side to side; then front to
back. If the range is not level, pull range
forward until the rear leveling leg is
removed from the anti-tip bracket. Adjust
the leveling legs up or down. Then slide
range back into position. Check that
leveling leg is engaged in anti-tip bracket.
NOTE: Oven must be level for satisfactory
baking conditions.
7