After Installing Slider Cradle - Martin UCGS Series Operator's Manual

After Installing Slider Cradle

Martin Engineering M3786-03/19
Read entire section before beginning work.
1. Thoroughly wipe outside chute walls clean above Slider Cradle on both
sides of chute. Place a Conveyor Products Warning Label (P/N 23395) on
each chute wall visible to belt operator.
Failure to remove tools from installation area and conveyor
belt before turning on energy source can cause serious injury
to personnel and damage to belt.
2. Remove all tools and fire-retardant cover from installation area and
conveyor belt.
Do not touch or go near conveyor belt or conveyor accessories
when conveyor belt is running. Body or clothing can get
caught and pull body into conveyor belt, causing severe injury
or death.
3. Turn on conveyor belt for one hour.
Before adjusting Martin
lock out/tag out energy source to conveyor belt and conveyor
accessories.
4. After one hour of operation, turn off and lock out/tag out energy source
according to ANSI standards (see "References").
5. Make sure all fasteners are tight. Tighten if necessary.
6. Inspect cradle for wear. (A small amount of break-in wear may be found.
This will stop once bars wear to conveyor belt contour.)
7. If excessive wear, uneven wear, or some other problem exists, see
"Troubleshooting/Installation Checklist."
8. If necessary, adjust height of slider bars.
6
IMPORTANT
WARNING
!
DANGER
!
WARNING
!
®
Modular Slider Cradle, turn off and
®
Martin Modular Slider Cradle