Canon Servo EE Finder Instructions Manual page 18

18
CdS photocell which in turn activates the motor an d,
shifts the aperture to the full opening side.
5
When the main switch is set at "M", the EE
circuit is disconnected and the aperture can be
set manually:
• This method is not recommendable because the
servo motor circuit is not disconnected and the
power is consumed.
• The aperture cannot be manually closed down
beyond the flstop indicated in the meter reading
window, if the main switch is not set at "M".
6
When the shutter dial is set at "B", the EE
circuit is disconnected and the aperture needle
points to the bottom of the meter reading window.
In this case, the aperture can be also present manu-
ally.
• When using a shutter
speed at or slower than 1/8
sec., be sure to use the method as described in
item
If
3 by setting the main switch at the red dot.
Detaching Procedure
1
When removing, be sure to first detach the E E
Coupler before removing the Servo EE Finder.
Otherwise, the coupling socket will be damaged .
2
Slide the Servo EE Finder towards the rear while
pressing down on the attachment stoppers.