Advertisement
2. Remove the eight (8) screws holding the gauges to the bezel on the back of the system so the stock
gauges and lens can be removed from the bezel. The only item to be reused is the original front
bezel.
3. Test fit the RTX system into your bezel. If it fits properly, please move on to step 4.
•
There are two variations of the 65'-66' Mustang bezel. One has a "Hi" center speedo gauge
and the other has a "Lo" center speedo gauge. If the large round center speed gauge doesn't
fit properly into your bezel please remove the (4) screws shown below. Slide the center
speedo gauge to either "Hi" or "Lo" to fit your bezel. Replace the (4) screws and tighten until
snug.
4. Secure the RTX system to the bezel with the eight provided screws
Manual # 650707
Advertisement
