ArgoxScan AR-3000 Manual page 10

Programming the AR-3000
To program the AR-3000, you must scan a series of
programming barcode in the correct order. On the last page
of this manual, you will see a table of alphanumeric barcodes,
which are used to program the various options presented.
To program each option, you must:
1. Scan the Program barcode on the parameter setting part.
2. Enter the option mode by scanning the Option Bar Code
(also on the Parameter setting part).
3. To the right of the option barcode, the necessary
alphanumeric inputs are listed. Scan these alphanumeric
entries from the last page . To confirm above steps, you
must scan the Finish barcode on the last page.
4. Once you have finished programming. Scan the Exit
barcode, listed on the lower right hand corner of each
parameter setting part.
9