Golden Avenger GA541 Owner's Manual page 24

Step 4 - Remove the battery cover – This will give you access to the batteries, wire
connections, and the main connection pin.
Step 5 - Unplug the
Step 6 - Remove safety retaining clip from the ball detent pin and pull pin out.
Step 7 - With one hand grab top of seat post, with your other hand grab curved rear frame
support member. Lift and separate front half from rear.
AVENGER™ ASSEMBLY/DISASSEMBLY
INSERTED AND RETAINING CLIP RE- INSTALLED IN BALL DETENT PIN.
PINCH/CRUSH HAZARD!
BE CAREFUL NOT TO PINCH YOUR FINGER(S) BETWEEN FRAME HALVES DURING
RE-ASSEMBLY.
VII. DISASSEMBLY
following connections (see photos on the following pages).
1. Unplug the two gray battery connectors.
2. Undo the two Velcro retaining straps and remove batteries.
3. Unplug the large white main cable connector.
4. Unplug the small white charger connector.
5. Unplug the gray rear lights connector.
DO NOT SIT ON YOUR AVENGER™ UNLESS BALL DETENT PIN IS
Step 5, Number 1:
Unplug the two gray
battery connectors
24
.